Electrical

Seimitsu microswitch with integrated LEDs.
Make your Seimitsu buttons bright with this integrated led micro-switch.
Replace the original micro-switch with the one and connect the button with PSL-H cableVoltage 12V

Jack connector 2,1/2,5x5,5mm.
For powering illuminated arcade buttons or any other device requiring a voltage of 5V / 2A maximum.
Power indicator via blue led.

Jack connector 2,1/2,5x5,5mm.
For Audio Amplifier or 3.5 inch external hard drive, for example, or any other device with identical connections and requiring 12V / 2A.
Power indicator via blue led.

Front USB socket 3
To provide your arcade cab or bartop with a USB connection without having to open it.
2 USB 3 connectors.

Front USB socket 3
To provide your arcade cab or bartop with a USB connection without having to open it.
2 USB 3 female connectors.

Single switch not illuminated . Switch used for example in the pandora box 2 player arcade panels. 250V - 6A max. Connection by two 4.8mm terminals. External dimensions: 32.4x16.3mm Cutout 12.3x30mm. Fixing by clips, stroke of 2mm (32 to 30mm).

15V 4A power supply for Odroid H2 Plus or other equipment requiring 15V. Jack 2.1 x 5.5mm connector.

Power connector jack to screw 2.1 x 5.5mm. Socket. The electric cables are to be connected using the screw terminal block. The + and the - are marked.

Power connector jack to screw 2.1 x 5.5mm. Male plug. The electric cables are to be connected using the screw terminal block. The + and the - are marked.

Power cable for led tape with 2.1 x 5.5mm jack connector. Installs without soldering, just clip the quick connector directly onto the ribbon. For 10mm wide led strip only. Length: 15cm.

Power supply cable for any device with a 2.1 x 5.5mm jack connector. For arcade audio amp or ribbon leds for example. Cable length: 1 meter. Maximum power supported: 7A.

This ribbon will illuminate your marquees or even allow you to give a luminous aspect to your transparent arcade buttons, at a lower cost, by positioning it below. Please note that this article is sold in lengths of 10 cm. Example: for 50 cm, you will need to add 5 units to the basket. 12V LED strip Neutral white color. Class IP20. 60 LEDs per meter. SMD 5050 type LED, power between 14 and 16 lumens per LED. Ribbon width: 10mm

Power cable for seamless led tape. On / off switch. 2.1 x 5.5mm jack power connector. All you have to do is clip the connector on the led strip to power it. No soldering required. Compatible with 10mm wide led strips only. Length: 30cm.

Li-ion battery for PS3 wireless controller. Can also be used with the Brook Wireless Fighting Board Card to make a wireless arcade stick. Voltage 3.7V. 1800mAh power.